Two Garden Renovations

Share this post

coalport stool

Did you have garden furniture made by Coalport? Generally two or four ornate chairs with a table, these settings were Brunswick green or white. I’ve had this stool for a long time, so long I don’t remember anything about its origins. I’ve kept it because it is the perfect height for weeding! I sit with a bucket for the weeds and reach all around me, pulling them out and dropping in the bucket, then moving on and repeating. I frequently make weed tea out of the weeds as it is ready to pour back on plants in about ten days and gives them a boost.

Gathered my supplies and set to work.

This stool has lived a long and hard life and looked it, too. So I decided to renovate it. I especially wanted to treat the rust before it affected the integrity of the metal. The first job was giving it a good scrub and hosing it down. That got rid of dust, dirt and a spider.

Next was a coating of paint remover. Originally Brunswick green I intended to paint it black. The paint stripper was a gel which make the old paint loosen but also gel-like and the only way I could remove it was with a wire brush. This was hard work and took longer than I’d anticipated. Then I used a liquid rust retardant and converter all over the stool. About five days later it got rained on which cleared off the residual evidence of treated rust. Time to tighten the leg screws and let it dry out properly.

As this stool is sometimes left out in the garden I used another rust retarding product to paint it. This was a Rust Guard Epoxy Enamel. It resulted in good coverage but it had a matte finish and I wanted a gloss finish, so I completed the job with a spray paint. These pieces were built to last. Referred to as retro or vintage online, there’s a surprising number of chairs, tables and stools by Coalport for sale. This one is light enough to move fairly easily from place to place despite being manufactured from cast iron.

decorative fence panel

This panel will be attached to the fence. It started life as a screen but my son cut the legs off for me.

The second renovation was a panel for the garden fence. Originally a screen, I knew where I wanted to attach it to the garden wall as soon as I found it. The first job was getting my son to cut off the rusty old legs.  Then I gave it a good scrub before checking the strength of the welded joins. It’s old but in reasonable shape.

I coated the screen in paint remover and left it to work before using a scraper to remove the gel like dissolved paint. Messy. After I’d done one side, which took almost five hours, I flipped it over only to discover the old, cracked paint came off quite easily scraping at it. Still took ages but the gel was very messy and sticky, scraped off paint is easy to sweep up.

A coat of liquid rust remover, then a few days later I filled the cut off leg edges with builders filler. The screen will be attached to a wall where the lower part of it will be sprayed occasionally by the reticulation. Left the filler to harden for a few more days then sanded it to a smooth finish.

Sanded the builders filler used to seal the ends where we’d cut off the legs. I don’t have a workbench so improvise using the garden table covered by an old plastic tablecloth and sometimes the garden chairs, too.

Next was a coat of Rust Guard Epoxy Enamel, then finally I finished it with gloss spray paint.

Finished but resting in position on two bricks until I get the brackets to attach it to the wall. The timber slat screwed onto the wall to the left will stop the creeping fig from growing near the panel. I trim along another slat and the top of the fence to keep it under control.

These projects were very time consuming and hard work. I would probably investigate ways of having similar pieces sand blasted or stripped professionally if I had another project like these two. Once sand blasted they could be powder coated. Cleaning, stripping, treating the rust, sealing and repainting took many days. Although I am really pleased with the outcome, I wouldn’t want to remove paint from intricately patterned and pierced pieces again. I almost wore out the wire brush and myself!

Unfortunately, I have quite a long list of repairs or renovations to carry out in the garden, including resurfacing a chipped Chinese stool and restoring a small table. Might think about these jobs for a while!

Share this post